220
AVG 8.5 Internet Security Network Edition © 2009 Copyright AVG Technologies CZ, s.r.o. All rights reserved.
Define specific IP addresses of AVG stations for update distributions in the
manual mode. You can divide your clients into two groups, when you want to
define different rules for particular clients. This mode can be used even if
there is no AVG DataCenter support.
In the Time until next attempt to connect (minutes) specify the time (in
minutes), after which the server should try to contact stations that have not
been responding during the previous attempts. It will try to connect to all
clients until all of them are informed about the update or the allowed number
of connection attempts is exceeded.
The fields for each group are as follows (the X stands for the group number):
o
Clients IP addresses - Set X – the list of clients’ IP addresses;
available forms of values are: full IP address, station name, IP address
range (using the start and the end address of range, divided by a dash)
or address combined with network mask. Examples of address
specifications follow:
122.64.200.216 (IP address)
122.64.200.125-122.64.200.133 (IP address range)
station26 (station name)
10.10.2.0/255.255.255.0, 122.64.200.173 (subnet mask and address)
o
Max. number of connection attempts in Set X – the maximum
number of connection attempts for the given set; if set to 0, an
unlimited number of attempts is allowed. The default values are 1 for
the first set and 0 for the second.
o
Inform clients from Set X about update type of – select either
Virus database or Program using the respective radio button.
Note: When you put a station into both of the sets, it is taken as if it were in the
second one (the second set has higher priority). Thus you can define all your
stations in the first set and the stations with special rules to be applied in the
second one.
Note: Any AVG Managed Update related changes performed in the AVG Admin
Server Monitor configuration interface are saved after pressing the OK button.
The Server info button will open the following dialogue:
