Classification: Avery Dennison – Public
Setting Supply & Printer Options
2-3
S e t t i n g t h e S u p p l y P o si t i o n
Adjust the supply position to set where data prints vertically on the supply. The adjustments are
in steps (0.00333 inch). The default value is 0.
Enter the supply position value. The printing shifts as shown.
Select
To
+ (positive) value
Increase the setting. Moves the printed image down on the label.
- (negative) value
Decrease the setting. Moves the printed image up on the label.
S e t t i n g t h e O v e rf e ed D i st an c e
Adjust the overfeed distance to set the distance that your supply is fed out of the chute after it
prints. The adjustments are in steps (0.00333 inch). The default value is 0.
Select
To
Increase the value
Feed more supply out of the chute after printing.
Decrease the value
Feed less supply out of the chute after printing.
S e t t i n g t h e M a xi m u m S u p p l y L en g t h
Adjust the Max Supply Length if you are using supply that is longer than 8.0”. The size of your
supply is measured from top to bottom. The default value is 8 inches. If your supply is shorter
than 8” you do not need to adjust this setting (the printer automatically detects supply that is 8”
or shorter).
Select
To
Increase the
value
Feed more supply out of the chute after printing.
Decrease the
value
Feed less supply out of the chute after printing.
