O n e - I n c h F e e d L e n g t h G u i d e l i n e s
When using RFID supplies with a one-inch feed length, follow these guidelines:
Adjust the supply and print positions according to this document.
Do not use peel mode, enable backfeed, or select overstrike for the error action mode.
Do not use the verifier with one-inch feed supplies.
A non-print zone exists at the trailing edge of each label, according to this document. The trailing
edge is the edge of the label that exits the printer last; regardless of how the format is designed on the
label.
Non-Print Zone
Trailing Edge
Leading Edge
The non-print zone varies
for 1” Feed RFID Supplies.
4” wide by 1” tall RFID Label
Print Position
Transponder Type
203DPI 300 DPI
Supply
Position
Non-Print Zone
Alien Technology® Higgs Squiggle
+40
+60
-50
0.30”
trailing
edge
Avery Dennison® AD-224
+70
+105
-70
0.35" trailing edge
Note:
The print and supply position settings are a recommended starting point. You may need to
adjust them based on your results.
4
RFID Setup Guide & Supply Chart