Avery Dennison LOKPRINT 676, User Manual

Page: 39 / 79

User Manual Model 676 LOKPRINT® Adjustments
• •• •
33
Feed Open
If the switch is in need of adjustment - first check and adjust as needed the feed
pressure as it will affect the switch adjustment. With the machine rear cover
removed while opening and closing the feed pressure knob you should heard the
switch clicking. If not, the switch bail is adjusted by carefully bending it as needed.
Machine Set Up Sequence
1) Power off the printer, remove the media and ink and thoroughly clean it from the
unwind to the stock exit using alcohol and a clean soft cloth. The print heads
should be cleaned as per the Print Head Cleaning instruction section in the manual.
2) Load a full roll of an average width media and ink on the printer.
3) Power on the printer. After passing diagnostics tests the front panel should display
READY FOR BATCHES if not then resolve any remaining error conditions.
4) Arrow down to the PRINT / CUT POSITIONS mode and press enter. Cycle
through all the prints, cut, and station two dot shift values to get a feel for their
present settings.
5) Cycle back to the beginning of the Printer Adjustment and press enter at Print
Checkout Format.
6) If all three print stations or stations two and three are present, adjust station
number two by moving the dots with the dot shift on the front panel so that the
tracking line on the front of the label becomes one continuous line.
The machine is now ready for production formats at which time the operator should
need only to fine-tune the prints and strobes via the front panel.