User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev.
2.14
21
Installation of option
for TTX 650 / LION / S 65
Attention:
Some of the options – like the dispenser module can only be mounted by service
personal ! Sometimes it is necessary that a module can be imbedded only from a
defines series number – see option manual.
Unplug main power supply!
•
Plug light-barrier connector and motor connector in. Both sockets are
located at front side of housing.
•
Fasten unit by means of 2 hexagon socket screws at vertical base plate
of printer.
•
Reconnect power supply and switch unit on.
Attention:
Hazard of injury in the initialisation process and during cutting because of moving
knife!
•
to activate the option go the parameter ‘PEPH’ and select the option with the
necessary parameter
•
follow the steps in the option manual
A special case is the color option – therefore you have to install a separat firmware
and add an additional sensor. For more details refer to the color manual.
connecting
