User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev.
2.14
18
Positioning of gap sensor
Depending on the printer different sensor are possible. Using the TDI two sensor are
available – through light and reflective. Using the TTX three sensor are possible (through
light, reflective and full size).
Between trough light and reflective there is a difference of 11 mm (adding). The optional full
size sensor is behind the standard sensor. The sensor can be moved across the web – and
the gap can be sensed . The minimum label width is extended to 38 mm.
Adapt sensor to the position of the gap by means of the adjusting knob located at the front
side of the print module.
Adjustment range: 2-15mm
across the web.
•
A scale is marked around the knob
•
Calculate position as follows. Measure distance between center of gap and left
edge of material reduce value. by 2 the results matches the adjustment value at
the scale
Sample :
Distance between center of gap and left edge of material 11mm
Reduction - 2mm
Adjustment value 9mm
With round labels punch - offset pre adjustment is possible at the printer (parameter
PUNO) or via Easy Plug command in order to correctly catch the label edge.
