![background image](http://html1.mh-extra.com/html/avery-dennison/1050-puma/1050-puma_user-manual_3030395014.webp)
User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev.
2.14
14
•
- only for TTX 1050
there is a special support which has to be opened before media can be loaded
or removed.
After removal or change of media – please close the support again.
-TDI/ EXXTREME/S TDI only-
Move paper tray down by means of simultaneously pressing ON/OFFLINE and
CUT key. Insert material to the left/rear corner of tray. Move paper tray up by
means of simultaneously pressing ON/OFFLINE and FEED key.
•
Adjust lateral material guides (red) that the material may move easily.
-TTX 650/ LION / S 65 only-
Press the red lift lever at the right, outer end of the print module in order to lift the
pressure rolls of the feed roller and insert material below the printhead.
•
Adjust both pressure roll units symmetric to material with so that material moves
smoothly.
•
On printer versions with installed knife a straight cut edge is required for perfect
material insertion.
Attention:
Do not touch feed unit with your free hand. The optional knife may cause
injuries with wrong key manipulations! On operation with open cover, fingers,
hair, clothes, jewellery, etc. may be caught by and get into the unit in the ribbon
feed section.