Configuring the scale
There are three ways to configure the scale:
Management mode
This mode allows the user to configure a few branches of the scale. Because the
configurations can be different for each scale, refer to the User Instructions for
details on the branches available.
To enter management mode:
To exit management mode:
Restricted service access
This will allow you to see all of the scales configuration.
You will not be able to alter the branches that are marked as 'Full service access
only', if you attempt to change these configurations you will see an error message
(E 152).
6
Service Instructions
Configuring the scale
Management
mode
Restricted
service access
Full service
access
Verification
mode
Configuration
menus
Service
calibration
6231
C