42
3.4.2.3
Record Setting
In the Recording setup window, click
OK
to accept the new settings, click
Exit
to exit without saving,
and click
Default
to revert back to original factory setting.
i
Some of settings are not available to the IP camera.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(11)
(12)
(10)
(9)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable the
ALL
check box. To select more than one camera,
Right click
on the camera icon. To select one
camera only,
Left click
on the camera icon. The camera icon turns red when it is selected.
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select the
recording mode and click the
button. If you want to only record at a particular time, click the colored
block beside the recording mode then click on the time blocks. When the system starts recording a red
triangle mark would appear at the upper left corner of the screen. The recording modes are listed
below:
-
Always Recording
Record the video from the selected camera and save it to the designated storage path
-
Motion Recording
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop based
on the
Start Record Prior
and
Stop Record After
settings.
-
Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is detected
and if there is no motion, it records at the minimum frame rate setting. Set the maximum and
minimum frame rate setting in
(7) Frame Rate
section.
-
Vovice Detection Recording
DVR system will record when the voice exceeds the intensity value in
Voice Detection
setting.
-
No Recording
