UVC Ultraviolet Sterilization and Purification Lamp
TM
Date: 22 January 2021
Page 3 of 8
Rev A
Manual of remote controller:
Manual of remote controller (choose the mode before using)
Two modes: standard mode and automatic mode, switch button under back battery.
Manual of remote controller (please select mode before using)
1. Two mode: standard mode and automatic mode, swift button under back battery.
2. Standard mode: the lamp not automatic on after 2 minutes without detection.
3. Automatic mode: the lamp automatic on after 2 minutes without detection.
4. Power the lamp with voltage within the range on lamp, otherwise the lamp will be broken.
5. Press the "lock" button to start. choose any button, it will take around 18 seconds to turn on after the sounds stop.
6. The continuous sounds to warn people out of the disinfection area asap.
7. Five different disinfection time setting (ON/30MIN/60MIN/90MIN/120MIN); "ON" means no time limited.
8. If you want to cancel the time setting, press OFF. Each time the lamp sounds around 18 seconds then on without detection.
9. Our remote controller is well paired with lamp one on one, considering about too sensitive signal.
10. You need press "120MIN" button within 5 seconds when the lamp on to match another lamp and then control.
Note: Other buttons are out of function, If the "lock button" not pressed
PurpleTube Unit 254
Remote Control
Standard mode:
When the module is triggered to turn off the
light, it will not start automatically after
detecting no one there. If you need to turn on
the light, you need to press the ON button.
Automatic mode:
When the movement detected, lamp turn
off; then lamp will turn on in 2 minutes
when no movement detected; and it will go
for repeated process like this if any
movements detected.
