1. From Rack (Control System Direct):
Plug a MONO 3.5mm cable into an emitter port of any control system
directly into the "IR IN" port on the FO-HDM2-T4K-T Transmitter to pass IR signals directly to the remote end.
NOTE - Be sure the IR MODE Slide Switch is set to "I-PASS" on the Transmitter.
2. From Rack (Using IR-EYE):
Plug an IR-Receiver Eye into the "IR IN" of the FO-HDM2-T4K-T Transmitter in order
to pass infrared signals generated from a device or IR Remote. NOTE - Be sure the IR MODE Slide Switch is
set to "IR-EYE" on the Transmitter.
3. From Remote End:
Use an IR-Receiver Eye on the FO-HDM2-T4K-R Receiver (IR In Port) in order to send IR
signals BACK to the rack and out of the TRANSMITTER IR Out Port with an emitter.
4.4
IR CONFIGURATION
16
Rev.00 03/2018
www.avenview.com
