4.1.7
TROUBLESHOOTING TRANSMITTER
12
Rev.00 03/2018
www.avenview.com
POWER - On the front (Setting Light):
(Red) the setting light doubles as the POWER indicator. This is an
indicator that the power is connected. There are only two states for light:
- Light Is On = Power supply is connected and functioning.
- Light Is Off = Power supply is not connected or there is no power present. (In order to have power: check
the power supply, USP, Outlet, etc...)
HDMI STATUS - On the back (By HDMI Port):
(Blue) This indicator shows that the HDMI Source is
connected. The states are:
- Light Is On (Solid) = Sync w/ HDMI source is correct and solid.
- Light Is Flashing = The light flashes during the sync process. If it is flashing continuously, a picture may not be
present
- Light Is Off = User can try and check the following below:
If the red HDMI signal status light is flashing or off, check the following:
- The source. Plug it directly into the display to be sure it's functioning properly.
- Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths.
- Set the EDID to state #1 (Please use a UNIVERSAL DIGITAL/ANALOG AUDIO CONVERTER FOR
DOWN MIXING).
- If these suggestions do not work, enable the "Test Pattern" (Please use a UNIVERSAL DIGITAL/ANALOG
AUDIO CONVERTER FOR DOWN MIXING). If you see the pattern, the problem is between the source
and the transmitter, please try a different source.
- Contact Avenview support if these suggestions do not work.
