www.avenview.com
Page
3
2.
INTRODUCTION
The
Avenview CTRLPRO-VWIP
, IP Controller simply provides communication to our HDM-C6VWIP-SET and third party
controllers to communicate, Telnet and RS-232 commands to automate high definition video and high quality audio to many
screens. This device can be accessed from a WEB Browser and allow control commands to Avenview Video IP solution
allowing connection by the following:-Point to Multi- Point with CAT5/6 requires a Managed/Unmanaged Network Switch
(Cisco SG300 & SG500 series) which supports port based IEEE 802.1Q VLAN, IGMP v2.0 or above protocol. For large
application, we would recommend Dell Networking 5500 series. Matrix Function –with CAT 5/6 cable without any signal loss
add multiple Sources to multiple RX which links via LAN by cascading Managed Ethernet switches up to 3 levels, to the Rx
connected to the HD Monitors at different locations on the Network. Transporting Full HD 1080p video and internally JPEG
video compression adapts to available network bandwidth if needed while retaining vivid picture with 5.1 PCM audio.
Videowall Function
with CAT 5/6 cable without any signal loss add multiple Sources to multiple TX and RX to the HD
displays to achieve a Multi Input videowall configuration. The device ensures flexibility within any videowall design, layout and
configuration. Its modular design allows example 1x2 ,2x2 3x3 up to 16x16. Easily controlled via the Control Software to
manage and setup the bezel, input and configuration of the Videowall.
The
CTRLPRO-VWIP controller
has the ability to communicate via telnet or RS232 from third party control systems such
as Crestron ,Amx, and Control 4 to perform matrix switching and videowall fucntionality.
NOTE: The QUALITY and TRANSMISSION of the video signals depends on the characteristics and quality of the UTP cables and
Network Infrastructure . We recommend any Network Switches with 10GB POE IGMP v2.0 support . Tested and configured on
the below models
. Downloads of how to guides available on Avenview website
