Avenview CTRLPRO-VWIP, User Manual

Page: 19 / 25

Command vw2 add vw-name rx1 position rx2 position
Return videowall2 item vw-name(n*m) configuration added:
rx1 position1
rx2 position2
...
Note Configure the video wall vw-name and add the corresponding TX and RX.
E.g.: “vw2 add wall1 Screen1 1 1 Screen2 1 2 Screen3 2 1 Screen4 2 2” Sets the RX units with alias’
Screen 1 to 4, to the noted x y positions in the video wall. Note a video wall by the name of wall1 must
have already been created using “vw2 add wall1 2 2 tx1 tx2” before this command can be used.
Command vw2 add vw-name layout n m TX1 RX11 RX12 … RXnm TX2 RX21 RX22 ... RXnm
Return videowall2 vw-name layout n*m tx1 rx11 rx12 … rxnm rx1 tx2 rx21 ... rxnm
Note Add a video wall layout n*m, subsequently the RX based on display order. The Parameter Rx could be char-
acter ‘0’, indicates no need to change the corresponding RX.
E.g.: “vw2 add wall1 layout 2 2 Source1 Screen1 Screen2 Source2 Screen3 Screen4” Creates a 2x2 video wall
using RX1 for row one and TX2 for row 2.
Command vw2 add vw-name n m tx1 tx2 ... txn
Return videowall2 item vw-name(n*m) create and assign tx1 tx2 ... txn to it
Note Create a video wall configuration, and assign a TX for each row.
E.g.: “vw add wall1 2 2 Source1 Source2” Creates a 2x2 video wall using RX 1 for row one and TX2 for
row 2.
Video-Wall 2
The vw2 is a special command set used for multi-host mode if the tearing delay command fails to resolve the tearing on a
video wall.
Command vw2 rm vw-name
Return videowall2 item vw-name removed
Note Remove a video wall configuration
E.g.: “vw2 rm wall1” removes wall1 configuration from the
TX
Command vw2 rm vw-name rx1 rx2 rx3
Return videowall2 config change:remove rx1 rx2 rx3 hostname from vw-name
Note Remove one or multiple rx from video wall.
E.g.: “vw2 rm wall1 Screen1” removes Screen1 from the video wall
Command vw2 change vw-name tx1 tx2 tx3 txn
Return videowall2 vw-name config change:
row1 tx1
row2 tx2
Note Change the selected input or inputs of a video wall, replacing a tx alias with 0 means no change.
E.g.: “vw2 change wall1 Source1 0 Source3” Changes Wall1 inputs for row1 & row3 to rx1 & rx3
Command vw2 reset tx
Return videowall2 reset tx
Note Remove the video wall configuration of this tx and display a complete picture. (If this tx is in video wall mode, it
will only display part of the picture.)
www.avenview.com
Page 17