Command
serial -b param –r {on|off} “command-string” hostname1 hostname2 ...
Return
serial command received: <cr>
serial -b param –r {on|off} “command-string” hostname1 hostname2 ...
Note
Configure devices hostname1, hostname2 to pass through serial command. Command-strings cannot con-tain
“ & ”.
-b param, configure the RS232 format of TX/RX and connected peripherals, including Baud rate, Data bits,
Parity and Stop bits.
E.g.: -b 115200-8n1.
-r {on|off}, to turn on & off Carriage Return following the command-string.
hostname1 hostname2 ..., indicates the destination, could be multiple.
E.g.: “serial –b 9600-8n1 –r on !PWR01! Screen1 Screen2 Screen3” Sends the command !PWR01! to Screens
1, 2 & 3 with a carriage return at 9600 baud – 8 data bits, No parity, 1 Stop bit.
Command
Command device-name message-body
Return
Reply: the device process the command feedback
Note
Third-party controller or web ui pass through message-body to RX/TX.
Command
N/A
Return
notify endpoint {+ | -} tx/rx tx/rx {- | +} tx/rx tx/rx ...
Note
Notify the third-party controller if any TX/RX is dropped out or added.
Serial
Pass-through the serial command.
Command device-name message-body
Message Pass-through.
Notification commands send by the CTRLPRO-VWIP
Notification of.
www.avenview.com
Page 19
