Assembly
AVENTICS
| Joystick Type 531 | R417003072–BDL–001–AA
19
Eng
lish
3.
To connect another joystick, apply another CANbus cable to
the connector X12 at the joystick. Route the cable to the next
joystick and connect it to X11. Proceed accordingly to
connect more joysticks if applicable.
Refer to the Marex 3D manual if you want to connect more
than 4 joysticks to the Marex 3D controller.
The maximum cable length from the Marex 3D controller to
the last joystick is 300 m.
4.
Apply a torque of 0.4 Nm to fasten the M12 connectors.
5.
If no further joysticks are being installed, apply a
terminating resistor (AVENTICS material No. 8941054274)
to X12 at the last joystick.
There is no need to connect a terminating resistor to the
Marex 3D controller as one is already included in the device.
Abb. 4: CANbus connection Marex 3D controller to Joystick Type 531
1
Terminating resistor in the Marex 3D controller
2
Terminating resistor, material No. 8941054274
1
2
Summary of Contents for Marex 3D 531
Page 1: ...Assembly Instructions R417003072 01 2018 EN Marex 3D Joystick Type 531 English...
Page 26: ......
Page 27: ......
