- 41 -
G
Note 6: programming modes
TO BE PERFORMED WITH THE TELEPHONE DIALLER PREPARED ACCORDING TO ITEM
• AF53994R and AF909RS control panels. Perform a switching (from PROG to ON) by using
the mechanical key.
Under this condition, the control panels transmit their code which is stored by the dialler.
Should the control panel receive the alarm signal, the dialler will start its operating cycle
after a 30 s. delay ( PRE-ALARM).
The above condition allows to disable the dialler by disconnecting the control panel within
30 seconds.
• AF939R remote control. Press both the keys of the remote control. Under this condition,
the remote control transmits its own code which is stored by the dialler. The remote control
enables the operating cycle through the RED key and disables it through the GREEN key.
The dialler starts the transmitting cycle after a 30 s. delay (PRE-ALARM) from receiving the
command.
This allows to stop the dialler, within 30 seconds, through the green key.
• AF938R remote control. Press both the keys of the remote control for 5 seconds approx.
Under this condition, the remote control transmits its own code which is stored by the dial-
ler. In this case, after confirmation of the code storage, 2 beeps are emitted on pressing the
keys and, after 5 seconds a sound confirmation will be emitted. The remote control enables
the operating cycle of the dialler by pressing one of the two red keys.
• AF913R, AF913R, AF913R-M detectors. Connect the battery to the detector.
On suppling the detector, it transmits its own code which is stored by the dialler (in the
case of storage of the AF913R door-window detector, the microswitch 3, seated on the
detector, must be positioned on “OFF” to inhibit the signal of end of alarm).
The detector enables the operating cycle of the dialler by sending the alarm signal to it.
Detectors AF968R – AF913R – AF913R-M and remote controls AF938R enable the opera-
ting cycle of the dialler without the possibility of stopping the cycle.
1
C.415 10-06-2002 9:11 Pagina 41
