Avaya ERS 2500, Troubleshooting Manual

Page: 52 / 90

Configuring another call server and uplink port
Configuring another call server and uplink port can assist the auto configuration.
1. Use the
adac uplink-port <port>
command to assign the uplink port.
2. Use the
adac call-server-port <port>
command to assign the call server
port.
Replacing Unit
Replace unit to replicate configuration if AUR is enabled.
1. Follow the replacement guidelines in Avaya Ethernet Routing Switch 2500 Series
— System Configuration (NN47215-500).
2. Refer to the unit replacement section in the Troubleshooting Hardware section of
this document.
Check the status and number of devices
Auto configuration can stop being applied after a unit is removed from the stack.
Task flow: Check status and number of devices
The following task flow assists you to correct the auto configuration.
Troubleshooting ADAC
52 Troubleshooting November 2010