Page 36 - IP Office Integration
Page 36
Compact DECT - Installation Manual
DECT Configuration Software
38DHB0002UKFH – Issue 5 (27th October 2003)
DECT Handset as a Slave of a Desktop Phone
A DECT handset can be made a slave of an IP Office desktop handset.
Perform the following:
1. From Start | Programs | IP Office select
DECT Configuration
(the CCFP
application must not be runniing).
2. You will be given the option to switch off the DECT service. Select
Yes
.
3. The IP Office DECT Configuration menu is displayed.
Enter either the name of
the host IP Office or it's
IP Address
The number of the DECT
handset (identified above) and
the number of the desktop
phone will appear here (e.g.
201 – 203) after
Connect and
configure
menu has been
completed (see below).
Click here to access the
Extension Dialog menu (see
below). When completed,
the number of DECT
handsets available to be
twinned is displayed
Enter the password of the host
IP Office
Tick this box to gain access to
the
Connect and configure
menu and hence enable
twinning (see below).
The password must be that of the IP Office connected to the DECT.
4. Check that either the
Host Name
or
IP Address
is displayed. If not, enter
the IP address of the IP Office.
5. Click
on
Test
. If communication with the DECT has not been established,
check the connection between the PC and the DECT (see pages 23 and
24 respectively).
6. Click
on
Handset Extensions
to gain access to:
From the pull down list, select the extensions allocated to DECT (see
page 35). Click on
Add to the list
for each entry selected. These will
appear in the box below. If you wish to delete an extension from this list,
then highlight entry and click
Remove selected extension
. Click
OK
on
7. Ensure that the
Enable Desktop/Handset Twinning
box is ticked and click
on
Connect and configure
.