Avaya CallPilot 703t, Hardware Installation, Page: 48 / 52

To connect the server to power
1. Plug the server's AC power cord into the server's rear panel.
2. Plug the other end into a wall receptacle or power bar.
To start the server
1. Press the server power switch to start the server.
2. Observe the Power-On Self Test (POST) and initialization messages on the monitor.
3. Let the mini-setup sequence run until you are prompted to log in to the operating
system.
Note:
The system may perform multiple reboots. This is normal.
4. Ensure that the operating system logon window appears on the monitor.
Note:
If the logon window does not appear, refer to the CallPilot Maintenance and
Diagnostics guide for your server for troubleshooting instructions.
5. Proceed with the CallPilot server and switch configuration guide for your switch to
connect and configure the server and switch.
Installing the server and connecting the peripheral devices
48 Avaya CallPilot® 703t Server Hardware Installation December 2010