Avaya CallPilot 703t, Hardware Installation, Page: 27 / 52

What is next?
Remove the server cover so that you can inspect the interior of the server. See Removing the
side cover on page 27.
Removing the side cover
Introduction
This section describes how to remove the server's side cover so that you can work with the
interior components. The side cover is on the server's left side when the front of the server is
facing you.
To remove the side panel
Warning:
Risk of personal injury
Be careful when you handle the sharp edges of the side panel and chassis to prevent
personal injury.
Caution:
Risk of equipment damage
• Use an ESD wrist strap to protect static-sensitive components.
• Place the server on its side to prevent the server from accidentally falling over. This
provides greater stability. If you attempt to work with the server in its standing position, it
may tip over when you work with the interior components.
The following diagram shows how to remove the side panel. See the instructions for removal
below.
What is next?
Avaya CallPilot® 703t Server Hardware Installation December 2010 27