Avaya CallPilot 703t, Hardware Installation, Page: 30 / 52

IF THEN
For instructions, see Replacing the side
cover on page 30.
Replacing the side cover
Introduction
When you are satisfied that the server was not damaged during shipment, reinstall the side
cover.
To replace the side cover
Caution:
Risk of equipment damage
Ensure that there are no tools or loose parts inside the server chassis before replacing the
side cover.
1. Align the right edge of the server's side cover with the inside ledge at the front of
the server.
2. Ensure that the cover lays flat along the side of the server.
3. Insert the tabs along the top and bottom edges of the server's cover inside the slots
along the top and bottom of the server.
4. Push the cover towards the front of the server until the tabs firmly engage in the
chassis.
Note:
When correctly engaged, the cover clicks into place.
5. Tighten the two thumbscrews on the back of the server.
The following diagram shows how to: 1) align the tabs, 2) engage the cover, and 3) tighten the
thumbscrews.
Preinstallation requirements
30 Avaya CallPilot® 703t Server Hardware Installation December 2010