Avaya 3920, Installation Manual

Page: 31 / 60

4 Installing a Repeater
Installing a Repeater in a Normal Configuration 31
Planning and Installation Guide
Registering a Repeater Automatically
During automatic registration,
the repeater seeks out the base that is currently in
registration mode and registers itself to the base.
To register a repeater automatically, perform the following steps:
1
Set the base of the Avaya 3920 Wireless Telephone into registration mode
by pressing and holding the registration button on the base for 3 seconds.
The indicator on the base flashes.
2
Plug the AC adapter cord into the AC adapter input jack on the repeater.
3
Plug the AC adapter into a standard 120VAC wall outlet that is near the
base unit. The repeater must be near the base unit. The LED on the
repeater flashes briefly and then remains on. The repeater is now
registered to this base and is ready to use.
If the LED continues to flash, try registering the repeater again.
4
Remove the power and move the repeater to the selected location. The
repeater will stay registered to the base. Go to
“Procedure 2: Find the Right
Location” on page 33 .
Registering a Repeater Manually
If you are registering more than one repeater to the same base, you must
register each repeater manually. Note that this procedure only works when
registering a repeater directly to a base. You cannot add multiple repeaters in a
“daisy chain” using this procedure. For a daisy-chain configuration, see
“Installing a Repeater in a Daisy-Chain Configuration” on page 37 .
To register a repeater manually, perform the following steps:
1
Plug the AC adapter cord into the AC adapter input jack on the repeater.
2
Plug the AC adapter into a standard 120VAC wall outlet near the base unit
for 1 to 5 seconds and then disconnect it.
The repeater must be near the base unit.