Avantco DHC-13, User Manual

Page: 10 / 19

User Manual
2 www.AvantcoEquipment.com
Index
Parts Overview .............................................................. 3
Standard Accessories .................................................... 4
Operation Instructions .................................................. 4
Figure 1: Gear Axle ........................................................ 5
Figure 2: Initiative Axle .................................................. 6
Figure 3: Fork ................................................................. 7
Figure 4: Change Speed Axle ........................................ 8
Figure 5: Turning Plate and Mixing Axle ....................... 9
Figure 6: Single Phase Motor Diagram ....................... 10
Figure 7: Center Axle ................................................... 11
Maintenance and Protection ........................................ 12
Troubleshooting ........................................................... 13
Warranty Information ................................................... 13
IMPORTANT SAFEGUARDS
1. When using electrical appliances, basic safety precautions should always be followed including the
following:
2. Read all instructions.
3. Close supervision is necessary when any appliance is used by or near children.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is
dropped or damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair or electrical or mechanical adjustment.
injury.
8. Do not use outdoors
9. Keep hands, hair, clothing, as well as spatulas and other utensils away from beaters during operation to
reduce the risk of injury to persons, and/or damage to the mixer.
SAVE THESE INSTRUCTIONS
Cleaning
........................................................... 13
Cleaning and Maintenance
press the button (A) securing the tap to the machine and then remove the
tap (B) with both hands, as illustrated in the figure;
7.5. Cleaning the pan
lt is necessary to remove all parts fitted to the pan.
Remove any product left in the bowl, see paragraph 7.2;
remove the bowl from the machine, see paragreph 7.3;
remove the tap from the machine, see paragraph 7.4;
clean the entire surface of the pan using a damp cloth and/or a non-abrasive
sponge;
clean the channel connecting the bowl and the tap, using a cleaning brush,
as illustrated in the figure;
refit the tap;
pour a little water inside the pan;
use the tap to drain out all of the water from the pan so as to eliminate any
small product residues inside the dispensing channel.
- 13_ EN -
SL32000 184 6 E d.03 - 06/2008
04/2010
7.5 Cleaning the pan
WWW.AvantcoEquipment.com 10