Avantco DHC-13, User Manual

Page: 9 / 19

User Manual
2 www.AvantcoEquipment.com
Index
Parts Overview .............................................................. 3
Standard Accessories .................................................... 4
Operation Instructions .................................................. 4
Figure 1: Gear Axle ........................................................ 5
Figure 2: Initiative Axle .................................................. 6
Figure 3: Fork ................................................................. 7
Figure 4: Change Speed Axle ........................................ 8
Figure 5: Turning Plate and Mixing Axle ....................... 9
Figure 6: Single Phase Motor Diagram ....................... 10
Figure 7: Center Axle ................................................... 11
Maintenance and Protection ........................................ 12
Troubleshooting ........................................................... 13
Warranty Information ................................................... 13
IMPORTANT SAFEGUARDS
1. When using electrical appliances, basic safety precautions should always be followed including the
following:
2. Read all instructions.
3. Close supervision is necessary when any appliance is used by or near children.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is
dropped or damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair or electrical or mechanical adjustment.
injury.
8. Do not use outdoors
9. Keep hands, hair, clothing, as well as spatulas and other utensils away from beaters during operation to
reduce the risk of injury to persons, and/or damage to the mixer.
SAVE THESE INSTRUCTIONS
Cleaning ........................................................... 13
Cleaning and Maintenance
unhook the bowl hook-on handles, as illustrated in the figure, to free the bowl slide the mixing auger upwards with one hand, taking care to grip it by the
place the bowl on a flat surface and using both hands, romove the gasket by
sliding it upwards in the direstion shown by the arrow.
Removing the tap is prohibited if the bowl contains the product
or any other liquid.
To remove the tap, proceed as follows:
move the rod to the maximum dispensing position;
rotation pin;
from the machine body;
release the bowl from the machine body, using two fingers to prise it away
from the fixed steel part of the mixer auger (A) and the others to grip the
outer edge of the bowl (B): Gradually pull the bowl harder until it comes away
from its seating;
slide the bowl upwards using both hands;
7.4. Removing the tap
SL 320001846 Ed.03 - 06/2008
- 12 EN
04/2010
7.4 Removing the tap
WWW.AvantcoEquipment.com 9