Avantco DHC-13, User Manual

Page: 14 / 19

User Manual
2 www.AvantcoEquipment.com
Index
Parts Overview .............................................................. 3
Standard Accessories .................................................... 4
Operation Instructions .................................................. 4
Figure 1: Gear Axle ........................................................ 5
Figure 2: Initiative Axle .................................................. 6
Figure 3: Fork ................................................................. 7
Figure 4: Change Speed Axle ........................................ 8
Figure 5: Turning Plate and Mixing Axle ....................... 9
Figure 6: Single Phase Motor Diagram ....................... 10
Figure 7: Center Axle ................................................... 11
Maintenance and Protection ........................................ 12
Troubleshooting ........................................................... 13
Warranty Information ................................................... 13
IMPORTANT SAFEGUARDS
1. When using electrical appliances, basic safety precautions should always be followed including the
following:
2. Read all instructions.
3. Close supervision is necessary when any appliance is used by or near children.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is
dropped or damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair or electrical or mechanical adjustment.
injury.
8. Do not use outdoors
9. Keep hands, hair, clothing, as well as spatulas and other utensils away from beaters during operation to
reduce the risk of injury to persons, and/or damage to the mixer.
SAVE THESE INSTRUCTIONS
Cleaning
........................................................... 13
Cleaning and Maintenance
To fl t the tap correctly back in place proceed as follows;
Note: t he tray needs to be emptied out a nd cleaned every t ime
that the red float fitted to the grid rises; thi s is to stop llquid
from leakin g out.
lift the tray with grid and pull it outwards to remove it from lts seating;
wash the tray and grid separately with lukewarm water.;
dry all of the components;
reposition the grid on top of the tray;
fit the tray back in place and press down to secure it to the machine.
Carry out the following steps:
prepare the sanitising solution
(see paragraph 7.7);
fill the bowl with the sanitising solution;
leave the solution to act for about 30 minutes;
empty out the sanitising solution from the bowl;
then rinse out the bowl and inside surfaces thoroughly to elim inate all resi-
dues of sanitizing solution.
SL320001846 Ed.03 - 06/2008
- 17 EN -
Remove the bowl lid from the machine;
Warning! the thermostat must be set to - OFF-.
in sanitising product.
rinse thoroughly using clean water.
clean the surface using a damp cloth and/or a non-abrasive spong e soaked
T he drip tray should be emptied and cleaned dally.
hold down the button , making sure that the rod is completely extracted;
introduce the tap into the seat provided and push until the pushbutton re-
turns to its initial position.
7.8.3 Fitting the tap
7.10.Cleaning the drip tray
7.9. Internal sanitization
7.11. Cleaning the bowl lid
04/2010
7.8.1 Fitting the tap
7.9 Internal sanitization
7.10 Cleanining the drip tray
7.11 Cleaning the bowl lid
WWW.AvantcoEquipment.com 14