- 8 -
User Manual
Operation Instructions
• Startup: after proper installation, connect the water source and turn on the power supply, the
machine will start working. Please confirm that the machine is operating normally when you
turn it on for the first time.
• Self-check: with power on for the first time, the ice maker will do a self-check and pump out
any remaining water.
• Preparing: after the ice machine is energized, the inlet valve opens and the inlet water will
flow in until it reaches the set level; then the ice maker will defrost one time.
• Ice making: after pre-cooling for 30 seconds, the water pump starts, the water flows through
the evaporator smoothly and evenly, the ice cubes are gradually formed in the ice cube tray.
• Ice Harvest (Drop): after the ice making process, the water pump is turned off, the defrosting
valve is turned on, and after the hot gas enters into the evaporator for about 1-2 minutes, the
ice cubes slide from the evaporator into the storage bin.
Warning: Do not put your hand into the ice storage bin during the ice-falling process to
prevent the ice from hitting your hand!
• Shutdown: The ice maker will stop working when you push the “on/off” button on the control
panel during the running process.
• Bin full stop: in the running state, with the storage bin filled to a certain height, the ice sliding
board cannot be rebounded or reset because of the block of the freshly produced ice cubes,
the ice maker will stop in 40 seconds.
• Repeat ice-making: when the ice cubes on the ice sliding board are taken away, the ice
maker will go back to the ice making process in a few seconds.
