30 (34)
7.6.2
Installation
It is also possible to attach the cutting head on the left hand side of the cutting arm, but it must be done
carefully. The cutting head is mounted on the left of the cutting arm by using existing fixing points.
WARNING
Risk of serious injuries - Assembly instructions are intended for persons who are
experienced and have training about hydraulic assemblies.
Wrong assembly
procedures and work methods can result in personal injuries. Wrong installation order of
hydraulic or mechanic components can cause injuries during assembly work, or cause
the attachment to operate in a way that causes risk of injuries. Contact your Avant dealer
or service if you are unsure about safe procedures, or need more information, or
installation service.
1
Remove the guard (1) and release the tension
spring (2).
2
Undo the fastening screws of the guard (1) and
turn the bracket (3) the other way around.
3
Undo the fastening screws and lift the cutting
head up with a lifting device carefully. Turn the
cutting head approximately 180 degrees on the
other side of the cutting arm. Make sure that the
routing of the hydraulic hoses will not prevent
the reinstallation, and that they will not get
squeezed or chafed against sharp edges.
4
Remove the locking pin and turn the cutting arm
to the desired position on the left hand side.
Lock the arm with the pin.
Summary of Contents for A440199
Page 2: ...Fence mower 2021 1 ...
Page 34: ......