19
ConteraIP
®
Omni LX RS Installation Manual
4.
Remove the conduit plug on the junction box adapter, then connect ¾” NPT conduit to the
junction box adapter.
Reference #
Description
1
Remove conduit plug
2
Connect ¾” NPT conduit to junction box adapter (Recommended:
use of waterproof tape)
NOTE:
Use silicon or water pipe seal tape to make sure there is no water leakage between conduit
pipe and junction box adapter.
5.
Run the ethernet cable and outside power cable (if necessary) through the rubber gasket which is
supplied, then pass through the Junction Box Adapter and AV-WMJB-W, Wall Mount Adapter.
Ensure the gasket is sealed properly.
6.
Attach the Wall Mount Adapter (AV-WMJB-W) to the Pole Mount Adapter (AV-PMA-W) as shown
below
.
Reference #
Description
1
Steel straps with compression screws
2
AV-WMJB-W wall mount
3
CORS-CAP-W mount cap
4
AV-PMA-W pole mount
5
Apply Teflon waterproof tape to the thread of ¾” NPT pipe to avoid
water leakage
7.
Use two Steel Straps which are supplied to attach the Pole Mount Adapter to the pole and tighten
the compression screws.
8.
Refer to the Wall Mount section for attaching the camera to the Wall Mount Adapter (AV-WMJB-
W).
9.
To configure the camera, refer to the Camera Discovery, Set-up and Configuration section.
