QA47.03 installation manual sola-cure 2020 rev c.
Auxano Technologies Ltd, www.sola-cure.com
OPERATION METHOD
There are 2 options available for operating a spring mechanism Sola-Cure blind
A.
Pulley cord operation
B.
Handle
PULLEY CORD
23.
The pulley cord runs over two
binding screws in the bottom rail of the
blind.
24.
One
end of the
cord is fixed
using the
base piece
or anchor
point (see
left). Pull the
cord to the desired position vertically
underneath the rail. The cord should be
at 90
⁰
to the bottom rail.
25.
The base is fitted with two small
screws and the cord is fed under the
base (note the groove on the underside
of the base). Tie a knot in the end of the
cord to prevent it from being pulled
back under the base piece.
26.
On the opposite side of the bottom rail, the cord should also be held vertically underneath the other
rail.
27.
The cord will feed through a small wheel (pulley square - see below left) and then into the pulley
clamp (also below right). Using the pulley square allows the clamp to be placed at 90 degrees to
the vertical cord in a location favourable to the operator.
28.
Feed the cord through the pulley square and then through the pulley clamp.
29.
The arm on the pulley clamp will be used to clamp and release the cord which dictates the position
of the window blind.
30.
Excess cord can be tidied around the cleat, also provided.
