QA47.03 installation manual sola-cure 2020 rev c.
Auxano Technologies Ltd, www.sola-cure.com
STABILITY AT SEA
9.
There are 3 options available for providing stability at sea.
a.
Wire guides
b.
Retaining pins
c.
Side rails
Check with the purchase order to confirm if any of the above options are specified.
WIRE GUIDES
10.
Wire guide bases (below) can be fitted on any surface below (top mounted blinds) or above
(bottom mounted blinds) the window, at any angle. The body of the base can be rotated to ensure
the wires are parallel to the window.
11.
Pull the blind down by hand. Leave just enough height to place the wire guide base.
12.
Take one of the wire guide cables and extend it vertically down, threading it through the rail and in
to the top of the wire guide base. Push down and through the base.
13.
The base has an internal clamp to retain tension applied in the wire. To release, press the top of the
base down.
14.
Position the wire guide base as shown below. The cable must be 90 degrees to the cassette.
15.
For additional tension, pull the wire through the base. Using long nosed pliers. It is possible to increase
the tension in the wires by pulling the wire through further.
16.
Excess cable can be cut away using snips or other suitable tool.
17.
Repeat the above for the second wire guide.
