background image

P. 2 

User Guide

 

Table of contents

Introduction .......................................................2

 

Vehicle Presets .................................................2

 

Heater and Heated Seat ...............................2

 

Windshield Wipers, Radio and Headlights....2

 

Remote-starting Your Vehicle ...........................3

 

Setting Your Vehicle Into Ready Mode.........3

 

Remaining In Ready Mode ...........................3

 

Remote-starting ............................................3

 

Driving Off.....................................................3

 

Remote Starter Features...................................4

 

Idle Mode ......................................................4

 

Turbo Mode...................................................4

 

Valet Modes..................................................4

 

Panic Mode...................................................5

 

Cold Weather Mode......................................5

 

Advanced Features: Installation-programmable 
options...............................................................5

 

Arming the Starter Kill...................................5

 

Remote Door Locks......................................6

 

Ignition-controlled Door Locks Option ..........6

 

Secure Lock Option ......................................6

 

Remote Trunk Release Option .....................6

 

Starter Kill / Anti-Grind..................................6

 

Engine Run Time..........................................7

 

Troubleshooting Poor Transmitting Range Issues

..........................................................................7

 

LIMITED LIFETIME WARRANTY

....................9

 

 

 

Introduction 

This Module is a state-of-the-art remote car starter system. With many advanced function, 

this product will satisfy any one of the user’s expectations from high-end commodity systems, 

without neglecting the standard features commonly offered by entry-level starters. 

 

Please note: 

Button 

Ι

 is for 

START 

(by default). 

Button 

ΙΙ

 is for

 STOP 

(by default). 

Buttons 

Ι

 & 

ΙΙ

 (together) is for the 

TRUNK 

release function. 

The LED is NOT included in this model. 
The valet button is optional. 

 

Vehicle Presets 

Heater and Heated Seat 

When leaving the vehicle it is recommended to preset the accessory controls in preparation 

for the next remote start.  Settings for the blower motor (fan), front and rear, as well as 

heated seats (if equipped) should not be left on 

HIGH

.  It is recommended to leave the settings 

on 

LOW

 or 

MEDIUM

 instead. 

Windshield Wipers, Radio and Headlights 

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to 

become energized while running under remote start.  When leaving the vehicle you must 

ensure that the windshield wiper and headlight switches are 

OFF

.  Leaving the headlight 

switch 

ON

 on certain types of vehicles could cause them to remain on even after the remote 

starter shuts down, resulting in a dead battery. 

Summary of Contents for AS-1291










Reviews: