User Guide
P. 5
Panic Mode
Note:
Panic mode can only be activated if the horn has been adequately configured
by your installer and if button
Ι
is programmed as
LOCK
or
UNLOCK
button.
In an emergency situation, you can activate panic mode using the
Ι
button. This will:
•
shut down the engine,
•
unlock the doors (with the
Ι
button)
•
or lock the doors (with the
Ι
button),
•
disarm the Starter Kill and
•
activate the horn for 25 sec.
Note:
See the description of the starter kill option later in this Guide.
To activate panic mode:
•
Press and hold the
Ι
,
button for approximately 3 sec. until the sound signal starts and
the parking lights flash: this will unlock the doors before the sound signal starts.
•
Or
press and hold the
Ι
,
button for approximately 3 seconds until the sound signal
starts and the parking lights flash: this will lock the doors before the sound signal
starts.
Panic Mode will automatically shut down after 25 sec.
Note:
To stop panic mode before the end of its delay, press the
Ι
button until the sound
signal stops.
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes
(or for 8 or 20 minutes with Diesel engines); the routine goes on for a period of 24 hours.
To
enter
Cold Weather Mode:
•
With the vehicle already in Ready Mode, press and hold the
ΙΙ
button until the
parking lights flash 3 times.
To
exit
Cold Weather Mode, do any one of the following:
•
Open the hood.
•
Start the engine using the remote control.
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
•
Press and hold button
ΙΙ
for 3 seconds
(until the parking Lights flash once)
•
Set the vehicle to Valet Mode.
Advanced Features: Installation-programmable options
The system was designed with flexibility and OEM integration in mind. With its programmable
options, this unit can control nearly any electrical system in your vehicle.
Note:
The programming of these features should be left to a professional. Changing any
one of the settings may adversely affect the operation the Module.
Arming the Starter Kill
Note:
Can only be activated if button
Ι
is programmed as
LOCK
or
UNLOCK
button.
If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm
automatically) or in Passive Mode (will arm automatically).
•
To
disarm
the Starter Kill in Active or Passive Mode, press button
Ι
on the transmitter. The
parking lights will flash twice. (If Remote Door Locks were installed, this will also unlock
the doors.) In Passive Mode, the system will automatically rearm 1 or 3 minutes after the
doors were unlocked.
