36
11.5 Output response in different operating states
OUT1
OUT2
Initialisation
OFF
OFF
Normal operation
according to the level and
OU1 setting
according to the level and
OU2 setting
Fault (E�0xx)
OFF for FOU1 = OFF;
ON for FOU1 = on
OFF for FOU2 = OFF;
ON for FOU2 = on
12 Technical data and scale drawing
Technical data and scale drawing at www�autosen�com�
12.1 Setting ranges
[LEnG]
cm
inch
Setting range
10���160
4�0���63
Step increment
0�5
0�2
[OFS]
cm
inch
Setting range
0���100
0���39�4
Step increment
0�5
0�2
The setting ranges for the switching limits (SPx, rPx, FHx, FLx) depend on the
probe length (L)� In general the following applies:
cm
inch
min
max
min
max
SPx / FHx
1�5 (3�5)
L - 3
0�6 (1�4)
L - 1�2
rPx / FLx
1�0 (3�0)
L - 3�5
0�4 (1�2)
L - 1�4
Step increment
0�5
0�2
The values apply if [OFS] = 0� The values in brackets apply to the setting [MEdI] = [LOW]
(setting for the detection of oils and oil-based media)�
• rPx (FLx) is always smaller than SPx (FHx)� If the value for SPx (FHx) is reduced to a value
≤ rPx (FLx), the position of rPx (FLx) also shifts.
• If rPx (FLx) and SPx (FHx) are close together (approx� 3 x step increment), rPX (FLx) is
changed automatically when SPx (FHx) is increased�
• If there is a greater distance between rPx (FLx) and SPx (FHx), rPx (FLx) maintains the set
value even if SPx (FHx) is increased�
