![background image](http://html1.mh-extra.com/html/autoplugin/rcp-fm/rcp-fm_user-manual_3022697008.webp)
8
7.6.4
Ignition on (potential)
7.6.5.
Disable the output
7.6.6
Feedback for Defa Vehicle Unit
8.
Settings
reset
8.1.1
Apply factory settings
9.
Heater
errors reset
9.1.1
Clear all errors in heater’s memory,
resulting heater unblocking
* Factory setting
Recommended settings is marked in italics
2
–RCP turns off the heater if the battery voltage becomes lower than preset
4
– Signals appear only at the heater’s autonomous operation
5
– Signal is used for indication by all the hazard flashers. It uses 1-wire connection
to the hazard alarm button (see installation manual for details).
6
– Additional connections required (see installation manual), not available by
using plug-n-play cable
7
– For the car’s remote key only
Signals
The module has two connectors: 9-pin connector X1 (table 3) for input signals and
power connection, 10-pin connector X2 (table 4) for output signals, special signals
and CAN-bus connection. The first pin on each connector is marked by the key.
Table 3
X1 pin
number
Signal Name
Polarity
Wire colour
1
Hea
+
White
2
Heater_off-
-
Grey
3
He
+
Green
4
Heater_on-
-
Blue
5
Button
-
Brown
6
Timer _in
+
Orange
7
RC_in
+
Yellow
8
Ground
Black
9
Battery Power
Red
The signals to be necessarily connected marked in the table in Italics