5
programming button. Use additionally installed button as programming button in
case of permanent connection of the module.
It is necessary to stop the engine and the heater at first. Turn the ignition on,
press and hold the brakes pedal. Then 3 times press the programming button (each
time hold the button until LED goes off, about 1.5 seconds). Both direction
indicators in the CIP confirm entering to the setup mode with 2 flashes. Release
the brakes pedal finally.
Each setup item in the settings table is a 3-digit code. To enter a digit of a
code, shortly press the button so much times, as corresponds to a digit. The LED
and the direction indicators symbols in the CIP confirm each button press: the LED
briefly goes off, the left direction indicator flashes one time when the first or the
third digit of code is entered, the right direction indicator - when the second digit
of code is entered. To complete a digit entering, press and release brakes pedal.
The CIP confirms it with one flash of both direction indicators simultaneously.
When all three digits entered, the module checks the code for validity and confirms
it with the direction indicators flashing. The both direction indicators flash twice
simultaneously in case of valid code and flash twice alternately in case of invalid
code.
If entered digit is not correct, press and release brakes button until the module
indicates an error. Enter the code once more in that case. Several codes can be
entered without exit of setup mode.
Turn the ignition off to exit setup mode. New settings are saved in the nonvolatile
memory of the module and stored there regardless of whether the module is
connected or not.
Attention:
If you start the engine without exit Setup mode, new
settings will not be saved in memory.
To reset the module to the factory settings, enter the code 8.1.1. Both direction
indicators in the CIP should flash three times, confirming command execution.
Then the module exits Setup mode and restarts.
To clear all the errors in the heater’s memory and thus unblock the heater, enter the
code 9.1.1. Both direction indicators flash five times confirming errors clearing. If
unblocking of the heater is impossible, the indicators flash five times alternatively.
Pay attention
: when you apply unblocking function for the first time, RCP
remembers VIN code of the car. In the future unblock function will work only for
this car.
Settings Table (2)
2.
Heater
Timing
2.1.
Limitation of
heater’s total
operation time in
pre-heat mode
2.1.1
*Not applied
2.1.2
40 minutes
2.1.3
50 minutes
2.1.4
60 minutes
2.1.5
70 minutes
2.1.6
80 minutes
2.1.7
90 minutes
2.1.8
100 minutes
2.1.9
120 minutes
