22
NOTE: Before an attempt to remote start, the unit must be programmed for a
system type, Tachometer Check, Voltage Check or Timer Check.
If none of the check types have been programmed, The Remote start will have
not function properly
REMOTE START FEATURE PROGRAMMING:
FEATURE “C” PROGRAMMING:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
7
times (holding in on the 7th push) until
three
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature
‘C’
programming mode.
Press and release the transmitter button corresponding to the feature you
want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory
Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three
pulse
Four Chirps /
LED four pulse
1
3 Hours Timer
Start
2 Hours Timer
Start
2
Gasoline
Engine
Diesel Engine
Wait-To-Start
Light
10 sec
warm-up
Diesel Engine
Wait-To-Start
Light
15 sec
warm-up
Diesel Engine
Wait-To-Start
Light
20 sec
warm-up
3
20 minutes run
time
30 minutes run
time
10 minutes run
time
5 minutes run
time
4
Factory alarm
disarm with
channel 2 on
Without this
feature
5
+
Constant
parking light
output upon
Remote Start
Flashing parking
light output upon
Remote Start
