Ital E-Bike user manual - Edition 01 - 2020
16
• Stop and inspect the proper set up of your newly purchased bike, so as to more easily
recognize any anomalies at a later time
• If any defects are detected during these inspections, immediately contact your dealer.
• You can use your bike again only when it is safe.
Before each check, make sure that your bike is switched off and is not connected to
the power supply, so that you do not inadvertently start it.
CHECKLIST OF CONTROLS
TO PERFORM BEFORE EACH USE
c
hecking
the
Wheel
units
• Check that all the parts are properly mount
ed
.
• The hub of the wheel assembly should not move on the front fork or rear
monoarm
.
• The quick
release lever
on the
front
wheel
must
be closed and the closing knob
on
the rear wheel
must
be fixed and with the security lock closed.
• check the fixing of the security
bolt
(A) on the closing knob.
• Check the t
i
re pressure.
• Check the position of the valve which must be perpendicular with respect to the
rim
and not tilted.
• Verify the absence of external damage, foreign bodies and wear on the t
i
res:
• The entire surface of the t
i
re must still have the original tread pattern.
• It should not be possible to see the section of the t
i
re that is located under the layer
of rubber.
• There should be no dents, cracks, cuts or damage.
• Remove any foreign bodies (thorns, small stones, bits of glass, etc.) by hand or using
a small tool without spikes or blades.
CLOSE
CLOSE
A
