DPM3-E Electrical User Manual, 1st Edition
User Manual - DPM3-E Series Electrical Panel Meters
15
Programming of the scale
There are two methods for programming the scale, the
SCAL
method and the
tEACH
method.
2
CndSP
SCAL
InP 1
±
88
.
888
dSP 1
±
18888
InP 2
±
88
.
888
dSP 2
±
188
.
88
±
188
.
88
Dec. point
ENTER:
Vertical displacement.
UP:
Changes active digit.
SHIFT:
Horizontal displacement.
tEACH
Programming Key Pad
SCAL method
The input and display values are programmed manually. This method can be used when the
value of the signal at each points of the process is known.
tEACH method
The input values are introduced directly from actual electrical values. The input signal device
must be connected to the meter and operational when each point is programmed. The display
values are programmed manually. This method can be used when it is possible to bring the
process to the conditions of each one of the points to be programmed.
Weighted Average Filter P
0
to
9
(4Hz to 0.05 Hz)
Sets low-pass filter cutoff frequency (Fc) which allows the meter to smooth out undesirable
display reading fluctuations. The value can be modified through the
SHIFT
key. This parameter
will set in reverse order the cut-off frequency of the low pass filter, getting the filter deactivated
for 0 value.
