Page 6
SR35-KPD-REM
– 1st Ed. – 7/9/2020
IP66 Remote Keypad User Guide
Selecting Units to Monitor/Configure
When the Remote Keypad is attached to multiple SR35 starters on the Modbus network, the user can
switch between each unit by using the following method.
NOTE: To simplify this selection process, it is recommended that the host SR35 units are
configured with consecutive Modbus addresses.
Procedure:
Modbus
address of the
connected unit
Local..01
RUNNING
1) Press the ‘Right’ key
2) Address selection screen will be shown
Address
1
3) Press the ‘Centre’ key. Display will change mode
Address
1
Cancel
4) Use ‘Up’ or ‘Down’ keys to change address to the desired number (SR35 address). Press the
‘Center’ key to confirm
5) Remote display will return to the Status screen and display the new address
Local..02
RUNNING
