Page 7 of 26
7/9/19
LUBRICATION / SPECIFICATIONS
SPECIFICATIONS
Model LPE
500
LPE
700
Roll Corrugation (Teeth Per Inch) ............................ 4, 6 1/2, 8, 10, or 14 .................... 4, 6 1/2, 8, 10, or 14
Roll Size .............................................................................. 9” Dia. x 10” Long .......................9” Dia. x 14” Long
Power Requirements
Minimum Horsepower ..........................................................5 .......................................................7.5
Maximum Horsepower....................................................... 7.5 ..................................................... 10
Overall Height (With Legs*) .......................................................39” ...................................................39”
Overall Height (Without Legs*) ................................................24” ...................................................24”
Overall Height (Without Legs*) (With Auger Base*) ....31 1/2” .............................................31 1/2”
Overall Length ............................................................................. 43 1/2” ............................................ 43 1/2”
Overall Width ...................................................................................28” ...................................................32”
*Discharge Auger (Diameter).....................................................8” ...................................................... 8”
Length ................................................................................. 5’ or 10’ ...........................................5’ or 10’
Drive ........................................................................................ Belt .................................................. Belt
*OPTIONS:
Auger Base
Leg Pack
Discharge Auger
LUBRICATION - DANGER: Do not attempt to lubricate, adjust or service the roller mill while it is in operation.
BEARINGS - All pillow block bearings are sealed and as a general rule, REQUIRE NO LUBRICATION. However, the
bearing manufacturer does furnish grease zerks and recommends that the bearings be greased before 1/3 of the
bearing’s calculated life elapses. Usually a pump or two of grease every 100 hours of operation will be sufficient.
IMPORTANT: DO NOT OVERGREASE! Overgreasing can cause damage to the bearing seal. Each time the bearings are
greased, be sure to check the condition of the grease lines on the drive side of the mill.
GEARBOX (Discharge Auger Option) - The gearbox is filled at the factory, but the oil level should be checked initially,
and periodically thereafter. It is very important to keep the gearbox from running dry. There will be a slight leakage
around the seals so expect to add grease from time to time. Automatic recommends SAE 80 W-90 multipurpose gear
lubricant.
