LIMITS ARE PRE-SET IN FACTORY PLEASE READ THIS INSTRUCTION MANUAL BEFORE
ATTEMPTING TO INSTALL AND USE THE OPERATOR. FAILURE TO COMPLY WITH THE
INSTALLATION INSTRUCTIONS MAY RESULT IN SERIOUS PERSONAL INJURY AND/OR
PROPERTY DAMAGE.
T U B E / P I P E A S S E M B LY
STEP 1
Slide shuttle assembly onto index tube
(one piece only) and insert screwdriver or
clevis pin to hold it on tube and slide it into
support tube assembly. (FIG 1 & 2) Arrow on
shuttle must point towards Garage Door. To as-
semble the rest of the tubes, always slide short
insert tube half way into the long tube, then
slide other tube into remaining insert tubes.
Continue this process with remaining tube until
desired length is achieved.
STEP 2
The opener is supplied with a 9 teeth Drive
Sprocket on Drive Unit. If the Opener is to be
fitted to a one piece door without track, ex-
change the 9 teeth Sprocket on Drive Unit,
with a 7 teeth drive sprocket available as an op-
tion from ATA.
IMPORTANT
: If using Track Door (often
referred to as Panel Lift Door or Track Tilt
Door) use only 9 teeth Drive Sprocket on Drive
Unit. If using a one piece door without track
use the 7 teeth sprocket on Drive Unit.
STEP 3
Attach one end of chain (supplied) to chain
index screw, nearer to drive unit, using one
joint link. (FIG. 3)
Proceed to wrap chain around Drive Unit
Sprocket/Idler Wheel then go along the pipe to
the Idler Wheel on Support Pipe Assembly,
finally attach to the other end of the chain
index screw.
NOTE: Make certain that teeth of drive unit
Sprocket is engaged in the chain and that the
chain is not twisted. Make sure that the chain is
engaged in the plastic chain idle wheel on the
support pipe assembly.
FIG. 3
FIG. 1
6
FIG. 2
Summary of Contents for SECURALIFT
Page 16: ...PARTS LIST...
