10
ATS-3AM & ATS-2AM
Dominator Tempo & Syncro Instruction Manual
6.2 Mounting Operator for a Track Type Door
Fig.6.2.3
Fig.6.2.2
Fig.6.2.1
WARNING! To reduce the risk of injury to persons -
Use this operator only with a sectional door.
6.1 C-Rail Assembly
Fig.6.1.2
Fig. 6.1.1
6.2.1 Determine Bracket Position
a. Determine the centre of the door and mark this point with a line on the wall above.
b. Raise the door and find the highest point of travel of the first (top) door panel.
c. Using step ladder and a level, transfer this height to the wall above the door and
mark a line 2.36”(60mm) above it, across the centre line
(Fig.6.2.1)
.
6.2.2 Mounting the Wall Bracket
d. Draw two lines extending 0.846” (21.5mm) from each side of the centre point
(Fig.6.2.2)
.
e. Centre the wall bracket
6
over the intersection of these two lines. Mark centres
for at least two holes and ensure it is into a solid mounting point.
f. Drill holes in the wall with an appropriate bit.
g. Secure to the wall using:
(i) IF CONCRETE OR BRICK:
8mm (5/6”) loxins/dynabolts.
(ii) IF TIMBER:
wood screw #20 or similar (
minimum 1.97” 50mm long)
(Fig.6.2.2)
.
WARNING!:
Make sure concrete, brick wall or timber lintels are solid and sound so as
to form a secure mounting platform.
6.2.3 Attach the C-Rail to the Wall Bracket
a. Leave the drive unit in its packing box on the floor for protection and lift the other
end of the C-Rail.
b. Attach the C-Rail assembly
17
to the wall bracket
6
with the
3.54” (90mm) long pin
11
and secure with the supplied pin snap
9
(Fig.6.2.3).
6.1.1 Installing the C-Rail
a. Remove the Opener from the box.
b. Locate and insert the shaft of drive unit
1
into the C-Rail’s sprocket as shown in
Fig 6.1
.
c. Fix the two track brackets
16
with four (4) M4 x 8 screws
14
supplied in accessory pack (
Fig 6.1.2
).
d. Place drive unit back in packing box for protection.
Locate shaft into
the sprocket
17
1
16
14
60mm
Level
17
11
9
6
6
ELECTROCUTION!
This operator is
not equipped for permanent wiring.
Contact a qualified electrician to
install a suitable receptacle if one is
not available.
