20
Dominator EasyRoller Instruction Manual
6.11.1 Safety Beams
A Safety Beam Kit may be fitted to this opener. When this option is fitted, the operation of this device is such that if an object (i.e car, child etc) blocks
the Infra-Red beam, then the garage door opener will not close the door automatically. If the Safety Beam is fitted but not operating correctly, then the
door once opened automatically, will not close automatically.
6.11.2 Auto Close Option
Auto-Close mode is a function that automatically closes the door a preset time after the Safety Beams recognise that a vehicle has left the garage. The
Auto-Close timer only starts after the Safety Beam’s path is broken. If the safety beam path is not broken, the door will remain open until the path is
broken. If the opener incurs a physical obstruction (i.e. not from the Safety Beams) while closing the door, it will re-open and not Auto-Close until the
Safety Beam’s path is broken again.
To enable the Auto-Close function:
a.
Hold down the AUTO CLOSE TIME button.
b. While holding in the AUTO CLOSE TIME button, press the PLUS (+)
button - each press will add one second to the Auto-Close delay.
c.
To decrease the delay time Hold down the AUTO CLOSE TIME button
and press the MINUS (-) button - each press will deduct one second
from the Auto-Close delay.
d. Press the Operate button or transmitter to open the door. When the
door is fully opened the Open Limit LED will flash to indicate that
Auto-Close mode is operational.
e.
Break the Safety Beam’s path momentarily to initialise Auto-Close. When
the door reaches the fully opened position, the door will pause for the
set Auto-Close time and then close.
6.11 Auto-Close
WARNING! It is compulsory to have Safety
Beams installed when using Auto-Close mode.
Fig.6.11.1
AVERTISSEMENT! Le faisceau de sécurité
doit être installé lorsque vous utilisez le mode
Auto-Close.
