8
GDO-10V3L2 Toro
™
Owner Installation Instructions
6.1 Preparation
a. Check the door’s operation:
i. The door must travel smoothly and be easy to operate
by hand.
ii. Adjust any tight or twisted guides.
iii. Clean the guides if there is any oil or wax present using a
suitable white spirit. The only lubricant suitable for use on
door guides is silicon spray. DO NOT use WD-40, RP-7,
petroleum grease, or similar.
b. Install the locking bar covers
5
if there are locking bar holes in
the guides.
CAUTION - Do not lock your door with the locking bars
after installing the opener. Remove or disable the lock.
Security is not affected as the opener has an inbuilt
locking facility.
c. Affix the warning labels supplied with this opener in a prominent
place where they are clearly visible.
d. Choose the side where the opener will be installed ensuring
there is sufficient sideroom.
Check that the door is still balanced and smooth to operate. If it
is not, the door may require servicing (refer to door manufacturer’s
instructions).
6.2 Fitting The Opener
a. At the end opposite to where the opener will be fitted, check that
the door axle is tightened to the bracket securely.
(Fig. 6.1)
b. Open the door completely and tie safety ropes around the door
roll approximately 300 mm from each end. Do not tie the ropes
too tight as damage to the curtain may ensue.
c. At the end where the opener is to be fitted, support the door with
a safe and suitable lifter.
WARNING! Make sure the support is snug under the
door, is stable and will not move.
d. At the end where the opener will be fitted, use pen to mark the
position of the saddle on the door bracket and the position of the
door bracket on the wall to assist in reassembling.
e. Remove the bolts and saddle from the door bracket.
f. Remove the door bracket allowing the door to rest on the support
6.3 Mounting The Opener
a. If the internal gear does not rotate freely, switch the opener to
manual by pulling the disengagement handle down (there will be
a click), so the ring gear can be rotated by hand.
b. Slide the opener over the door axle and into the drum of the
door
(Fig. 6.2)
.
c. Ensure the internal gear is pushed in as far as possible (without
interfering with the door curtain) and that all of the door drum’s
wheel spokes are completely between the opener’s drive forks.
6. Installation
NOTE
- For minimum sideroom installations,
the door may have to be taken down.
WARNING! The opener must not
be used with a door incorporating a
wicket door.
WARNING! The door and its springs
are under significant tension.
Adjustments should only be carried
out by experienced persons, as
this function can be dangerous if
not performed under strict safety
procedures.
Fig 6.1
Fig 6.2
Tighten U bolts
