10
©
2007 Directed Electronics—all rights reserved
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release the single
button once within 2 seconds (or press and release the
optional Momentary switch).
2. Turn the ignition key to the OFF position.
(The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or
a shut-down input is received. (See the previous Remote Start
section for a complete list of shut-down inputs.)
NOTE:
This feature will not work if the brake pedal is being pressed.
Programming Options
Programming options control your system's normal operational
set-up. Most options do not require additional parts, but some may
require installation labor.
The following is a list of the programmable options, with the fac-
tory settings in
Bold
.
Valet Take-Over
G4101A_2007-06.qxd 06/22/07 3:17 PM Page 10