7
7.
Start using ADI-100 with the remote
control, please refer to the sections
on OPERATION CONTROLS and
STARTING UP THE SYSTEM.
Securing ADI-100, Step by Step
To secure ADI-100 on a chosen store location using the supplied dual lock tapes and/or
screws, do the following:
1.
Locate the positions on the back of ADI-100 and the chosen mounting location
(e.g. in the middle and under the car’s glove compartment) where you want to
apply the dual lock tapes.
2.
Clean both surfaces with alcohol if
avaiable and wipe dry before you start.
Affix the tape on the ADI-100 and the
chose mounting location
3.
Remove one side of the backing from
each of the two pieces of dual lock
tapes, and adhere the tapes onto the
back of ADI-100 on the marked positions
in 1.
4.
Remove the other side of the backing
and adhere ADI-100 to the chosen store
location with ADI-100’s cables and
connectors to the back.
5.
Carefully, remove ADI-100 from the store
location with dual lock tapes separated,
so that ADI-100 and store location each
has 2 half pieces of the tapes.
6.
Apply the pressure evenly to all 4 half pieces on ADI-100 and the store location,
so that the tapes adhere to both surfaces securely.
7.
Wait 8 hours, and then adhere ADI-100 to the mounting location by joining the 4
half pieces of the tapes together.
8.
Alternatively, or in addition, secure ADI-100 with the supplied screws.
Installation ‘Do’s & Don’t’s’
As ADI-100 has internal antenna and FM Transmitter, it is important to avoid signal
interference from excessive cable coiling.
The next page illustrates the do’s and don’t when coiling and storing ADI-100’s excessive
antenna cable and power cable.