INSTRUCTIONS CABRI-30P/35P
Page18
SWING GATE OPENER
3). The gap between the bottom of electric latch and the stopper should be less than 7mm.
Figure 2.3.5(10).
4). Connect the wires of the electric latch to the terminal LAT (+) and LAT (-) on the PCB.
Figure 2.3.5(10)
For the gate opened inward.
Figure 2.3.5(11)
For the gate opened outward
3) Control Box
Control Box Installation
1. Decide the installation position of control box first, it is suggested to be installed
near the gate and should be protected from possible damage. Be aware of the
motor cable length before deciding the installation position.
2. Remove the cover by unscrewing the four screws on the cover. Figure 1(1).
3. Use a screwdriver to puncture the holes beneath the bottom of the control box.
Figure 1(2).
4. Secure it on the wall. Figure 1(3).
Figure 1(1) Figure 1(2) Figure 1(3)
