AutoAnchor AA702, Owner'S Manual

Page: 35 / 57

34
3.10.1 MOTOR DRIVEN SENSORS
To select the motor driven sensor:
Scroll to Sensor.
Select Sensor.
Select Motor Driven Reed.
Select Gearbox ratio .
Increase or decrease the Gearbox ratio.
Save and exit to the Sensor set up menu.
Exit to the Windlass set up menu.
Press again for the Set up Menu and again
to return to start screen.
3.10 SENSOR SET UP
Default setting:
Standard - Applies to all AA sensors, reed switch
baseplate sensors and proximity sensors.
The default setting should
only be changed if you are using a motor driven sensor. (See below).
Note:
The sensor is tuned to the system on first use. See page 37.
3.11 SWAP CONTROLS
Default setting:
= Up and = Down.
Some operators prefer to use these buttons so that:
= Out and = In
Access the swap controls feature via the Windlass Set up Menu.
Turn the AutoAnchor Off.
Hold together to access the Set up menu.
Select Windlass.
Select Swap Controls.
Exit to the Set Up Menu or press again for the start screen.
Note: This feature can not be used to correct wiring errors.
Select Inside diameter.
Enter the measurement in mm or metric
inches (depending on the units selected).
Save and return to Drum winch set up.
Repeat for Outside Diameter.
Exit to Windlass set up menu.
Press again for the Set up Menu and
again to return to start screen.
3.9.4 TO ENTER THE INSIDE AND OUTSIDE DIAMETER
Outside diameter -
rode fully retrieved
Inside diameter -
rode fully deployed
Inside Diameter:
Outside Diameter:
Rode