Insert TF card: TF card slot to open the metal cover of the fuselage, the TF card chip
down, in contact with the chip to the bottom, then gently push up the lid, you can
wear.
2) How to recharge battery
The charger according to the interface connected to the charging port in the right
direction, (the lowest end of the machine on the right side there is a hole that is
charging interface) connect the power supply, the upper right corner (the terminal has
three indicator lights on top, where the rightmost the countdown to the first power
indicator light) should be displayed in red, represents charging in progress; when the
indicator must be lit, no light indicates charging status is not normal, you need to
check the interface and the power supply is plugged in; when charging finished,
indication light change to green.
Remark: can not long continue to hold the battery is fully charged, this will affect the
battery life.
Under normal situation, your mobile intelligent terminal can be used eight hours on a
single charge. When the power is reduced to a critical standard, then will show
battery low (main battery extremely low) warning message when the best time to
recharge. Please close immediately if you can not find a place to charge the power to
stop the use of mobile intelligent terminal. (Reminder: the case of insufficient power
to continue to use electricity consumption, resulting in a little electric batteries are no
circumstances that may arise battery can not be charged).
For fully activate the battery capacity, when you get a new battery when using the
method recommended by the general mobile phone battery "Charge and release 3
times each" to fully activate the battery capacity.
Your AIT26 every time the power transformer is connected, it will automatically
charge. When your SHT26 type connector adapter power supply, the red light is
charging; green light indicates that the battery is fully charged.
3) How to scan
：
1
、
press switch on button to turn on the PDA
。
2
、
start barcode scanning procedure
。
3
、
press Scan button
，
proceed to scan
。
How to scan properly
：
When scanning
，
press scan key ad see the red laser
，
do
not release the scan key
，
let the red laser cover the whole barcode
，
the red laser
will disappear after scanned
，
and a
“
tag
”
sound can be heard
，
and then release the
button
。
